Help

FAQ & installation

Every badge has a flat back with automotive adhesive already applied, and goes on in minutes with no drilling. Here's how, plus answers to the questions we hear most.

How to install Fit & placement Hood badges Materials & care Ordering

Installation

How to install

Takes about five minutes. Let the adhesive cure for 72 hours before washing.

Where it goes

Side badges: the flat panel just ahead of the front door is a great spot, or choose any other smooth, flat painted surface. They work whether or not your Grenadier has a snorkel.

Hood badges: made to replace the logo badge on the front of the hood. Rather keep your logo badge? The 2 in hood badge also fits any smooth, flat surface.

Hood badges only: remove the logo badge from the front of the hood and clean off any leftover adhesive.
Clean the panel with isopropyl alcohol and let it dry. Install above 60°F (15°C) for the best bond.
Dry-fit the badge and mark its position with low-tack masking tape.
Peel the backing, press firmly for 30 seconds, and avoid washing for 72 hours.

Not recommended for the bumper or other textured surfaces. A textured finish reduces how well the adhesive holds.

Fit & placement

Will these fit my Grenadier?

Yes, if it's a 2023–2026 INEOS Grenadier. Our badges are designed for both the Station Wagon and the Quartermaster. Every badge has a flat adhesive back that fits any smooth, flat panel.

My Grenadier has a snorkel. Will a badge still fit?

Yes. The badges stick to any smooth, flat panel, so a snorkel doesn't get in the way. The flat panel just ahead of the front door is a great spot.

Can I put a badge on my bumper?

We don't recommend it. The bumper and other textured surfaces don't give the adhesive a smooth surface to grip, so the bond won't be as strong. Stick to smooth, flat painted panels.

Can I remove a badge later?

Yes. Warm the badge gently with a hair dryer, then use fishing line or dental floss behind it to cut through the adhesive. Any residue comes off with an adhesive remover safe for automotive paint.

Hood badges

Materials & care

What are the badges made of?

Each badge has a PETG plastic body, covered with a clear UV-resistant epoxy dome and finished with a 2K high-gloss, UV-resistant clear coat. PETG is tough and impact-resistant, and it stands up well to fuel, oil and car-care products.

How do they handle heat?

PETG holds its shape up to about 155°F (68°C) and starts to soften around 175°F (80°C). That's far above summer air temperatures, though a dark-painted panel in strong direct sun can get very hot. If you live somewhere with extreme summer heat, a lighter-coloured panel or a spot that gets some shade is the safest choice.

Are they car-wash safe?

Yes, once the adhesive has cured (about 72 hours). We recommend avoiding high-pressure wands aimed directly at the badge edges.

Where are the badges made?

Every badge is designed and made 100% in the USA. We make each one ourselves rather than sourcing from overseas factories.

Ordering

Where do I buy?

Right here on our website. Use the "Buy now" button on any badge page to check out securely through Shopify. Badges marked "Coming soon" will get that button as soon as they're on sale.

How do limited editions work?

Every so often we release a special design in a run of just 25. We announce each one first on Instagram at @marketstreet_shop, then it goes on sale on our Limited edition page. Once all 25 are sold, that design is retired for good.

Do you make custom designs?

Not yet, but get in touch. If there's a badge you'd like to see, we'd like to hear about it. You can also message us on Instagram at @marketstreet_shop, where we share new designs first.